Pressure regulator M 30 C

Capacity up to 2 kg/h
Pressure regulators M 30 C are a part of chlorination system, and are designed for direct feed of gaseous chlorine under pressure.

GENERAL

Pressure regulators M 30 C are a part of chlorination system, and are designed for direct feed of gaseous chlorine under pressure, e. g. for open swimming pools and tanks at locations where it is not possible to provide an auxiliary power supply

 

The M 30 C consists of :

  • Pressure regulator

 

The capacities of the device vary from 0 - 2000 g/h, functioning on the principle of pressure in the chlorine cylinder with manual feed rate adjustment. 

OPERATION PRINCIPLE

Chlorine gas under cylinder pressure enters the regulator through the inlet valve, where the pressure is reduced to 1,2 bar. The gas then flows through the rate tube and the rate valve where the desired amount is set. The set amount of chlorine gas goes through the chlorine pipe and three way valve to the diffuser, where it is mixed with water. The diffuser is equipped with check valve to prevent the water entering the system.

INSTALLATION

System of pressure regulators M 30 RC is equipped with a pressure reducing valve which prevents the  chlorine gas to enter under high pressure. The pressure is reduced to a 1,2 bar maximum. Exhaust should be made so that the remainig chlorine gas in the pipline is neutralised. The diffuser should be mounted at least 1,2 m below water level and maximum of 7m, because the higher the feed rate the greater should be the depth. Because of the influences of temperature  and quality of the media, the bubbles and other factors, always choose the deepest point to insure best possible absorption.

Contact us for more info

Gas Types:
C=Cl2
CO2=CO2
S=SO2


Accuracy:
Within 4% of flow


Operating range:
20 : 1


System Weight:
Gross: 6,3 kg
Nett:   5,1 kg

 

System Dimmensions: 
500 x 250 x 280m


Connections

Connection to the cylinder:
1” (complies with DIN  477)

Other connections on request!